GB21518-2022

Minimum allowable values of energy efficiency and energy efficiency grades for AC contactors

交流接触器能效限定值及能效等级

GB 21518-2022 は現行の中国強制国家規格です：Minimum allowable values of energy efficiency and energy efficiency grades for AC contactors。業界：建設。テーマ：エネルギー効率。施行日：2024年1月1日。

適用可否は製品範囲、認証ルート、所管当局の通知、移行規定によって異なります。コンプライアンス判断に使う前に、翻訳をご依頼いただくか公式情報源をご確認ください。

コンプライアンス概要

この概要は現在英語のみで提供しています。

適用範囲

This standard applies to three-pole electromechanical, direct-acting integral AC contactors with a rated frequency of 50Hz, main circuit rated working voltage up to 1000V, and rated working current from 6A to 630A. It specifically targets contactors with a rated control supply voltage of AC 400V and below, categorized under utilization category AC-3. This standard is not applicable to external power-saving devices, household contactors, or semiconductor (solid-state) contactors.

技術要求

GB 21518-2022 establishes the energy efficiency grades and minimum allowable values of energy efficiency for AC contactors. The standard classifies contactors into three energy efficiency grades, where Grade 1 represents the highest efficiency level. The core technical requirement focuses on the holding power (apparent power consumed when the main circuit contacts are kept closed) under specific rated working currents. Manufacturers must ensure that the measured holding power does not exceed the maximum allowable values specified for Grade 3, which serves as the mandatory energy efficiency threshold. The standard also defines terms such as contactors of the same frame size and integral contactors to ensure consistent classification during compliance assessments. It references foundational low-voltage switchgear standards like GB/T 14048.1 and GB/T 14048.4 for general terminology and requirements.

試験方法

The standard outlines specific sampling procedures based on variations in rated control supply voltage and main circuit rated working current. Testing must be conducted in a controlled environment with an ambient temperature of 23°C ± 3°C and no load in the main or control circuits. The evaluation involves measuring the control circuit current once stabilized and calculating the holding power using the formula $S_h = U_s \times I$. Measurements require instruments with an accuracy of class 0.2 or higher, and the measurement uncertainty for holding power must be strictly below 5%.

よくある質問

What products are regulated under GB 21518-2022?

It regulates integral AC contactors (50Hz, up to 1000V, 6A-630A) used in AC-3 utilization categories, explicitly excluding solid-state and household types.

What is the mandatory minimum energy efficiency requirement?

The mandatory minimum allowable value corresponds to Grade 3 energy efficiency. Products must not exceed the maximum holding power limits set for this grade.

Are there specific environmental conditions required for testing?

Yes, testing must be performed at an ambient temperature of 23°C ± 3°C with sufficient power supply capacity and no loads connected to the main or control circuits.

The summary above provides a high-level overview of GB 21518-2022. To ensure complete compliance for your products entering the Chinese market, a precise and professional translation of the full technical specifications is essential. Purchase our high-quality English translation of GB 21518-2022 today to access all detailed parameters, holding power tables, and testing procedures.

適用のヒント

種別: 基礎
CCS: F01
ICS: 27.010
所管部門: Standardization Administration of China
技術委員会: National Technical Committee on Energy Fundamentals and Management of Standardization Administration of China