Описание на русском · Доступен перевод
GB24391-2009
Low pressure die casting machine - Safety requirements
低压铸造机 安全要求
GB 24391-2009 — действующий обязательный национальный стандарт Китая: Low pressure die casting machine - Safety requirements. Отрасль: Электроника. Тема: Безопасность продукции. Дата вступления в силу: 1 июл. 2010 г..
Применимость зависит от продукции, схемы сертификации, уведомлений компетентных органов и переходных правил. Закажите перевод или проверьте источник, прежде чем использовать эту запись в решениях по соответствию.
Обзор требований
Этот обзор пока доступен только на английском языке.
Область применения
This standard specifies the basic safety technical requirements for the design, manufacturing, and usage of low pressure die casting machines. It applies specifically to machines with crucible sealing and furnace body sealing, including both horizontal and vertical parting types. It is mandatory for manufacturers and suppliers of these specific casting machines to comply with this standard. Note that Chapter 3 is recommended, while all other chapters are mandatory.
Технические требования
The standard outlines comprehensive safety measures to mitigate mechanical hazards such as crushing, shearing, and impact from moving parts. It mandates specific protective devices for the mold danger zone, including interlocking systems for mold closing and pouring operations. Manufacturers must ensure that mold closing and pouring are strictly interlocked to prevent accidental ejection of molten metal. For high-pressure fluid systems, the standard requires compliance with general technical conditions for hydraulic and pneumatic systems to prevent explosion or leakage hazards. Electrical systems must adhere to relevant machinery electrical equipment standards, with specific provisions for high-temperature environments and cable shielding. The standard also references GB 5226.1 for electrical equipment safety. The document addresses thermal hazards by requiring reliable sealing between the holding furnace and the mold, along with strict interlocking mechanisms to prevent opening under residual pressure. Noise limits are specified to protect operators from hearing loss, and requirements for ergonomic design and electromagnetic compatibility are also included. Operators must be protected from smoke, oil mist, and potential fire risks associated with hydraulic fluids and mold coatings.
Методы испытаний
Compliance with the safety requirements is determined through a prioritized sequence of four verification methods. Functional testing is the primary method to verify the performance of specified safety components. If not feasible, instrumental detection is used to check if parameters are within limits. Further verification can be conducted through calculations and drawing reviews for structural stability, or finally, through visual observation to ensure required safety performance and proper usage information are present.
Частые вопросы
What products are regulated under GB 24391-2009?
GB 24391-2009 regulates low pressure die casting machines, specifically those with crucible sealing and furnace body sealing, including both horizontal and vertical parting configurations.
Is GB 24391-2009 a mandatory standard?
Yes, the majority of the standard is mandatory for manufacturers and suppliers. However, Chapter 3 regarding terms and definitions is recommended.
What are the key safety focuses of this standard?
The standard focuses on mitigating mechanical, electrical, thermal, and noise hazards. It places a strong emphasis on interlocking mechanisms for the mold danger zone and preventing molten metal ejection during operations.
The summary above provides a high-level overview of GB 24391-2009. To ensure complete compliance for your low pressure die casting machines entering the Chinese market, a precise and professional translation of the full technical specifications is essential. Purchase our high-quality English translation of GB 24391-2009 today to access all detailed parameters, interlocking logic diagrams, and testing procedures.
Подсказки по применимости
- Тип
- Безопасность
- CCS
- J61
- ICS
- 25.120.30
- Компетентное ведомство
- Ministry of Industry and Information Technology
- Технический комитет
- Ministry of Industry and Information Technology